Shop – Getting all the storage I can – Under the Out Feed Table

I noticed unused storage space under my out feed table. So I made some simple boxes to store what I can in the unused space.
I started by cutting 3 – 2 foot by 4 foot bases out of some left over plywood I had laying around. Then I screwed on some 2×6 decking boards:
Then put on 4 2 inch casters from Harbor Freight:
I got some storage containers from the Dollar Tree filled them up and labeled them:
Then slid it into place:

New Band Saw Setup

I got my new band saw, it is a Grizzly G0555Pwith the H3051PRiser Block Kit. Here is a shot of the saw without the riser or table:
Here is a shot of what comes with the riser kit:
Here is the saw with the riser kit installed:
Here it is all put together:

Lumber Storage Solution

I was looking for a lumber storage solution and I ran across Shop Notes 55 They call it a Roll-Around Store-All on page 24 of issue #55. The thing is cool!
So I built one. Started with the base:
I put the dividers in, I did not make mine as fancy. Still works as desired:
Then cut the shelves and added the tower:
I add a shot when I get it loaded up.