Kegerator Build

Here is what I started with. Just a basic freezer that you can pick up just about anywhere, Craigs List, Used appliance store, I got mine at HD for $168.00

 

I made the 2×8 frame using the guide of the inside lip, which is about 2 inches wide. I then added the pine facing using the outside lip as a guide, which is about 1 inch wide but is slightly higher that the 2×8 frame. This offset the pine facing (basically I was using the original freezer as a jig) This allowed for a nice seating of the freezer door.

 

 

 

 

I screwed it all together recessing the screws so I could putty them up later for a clean finish.
To get the lid to seal right I had to cut back some of the 1×8 to get the hinges to fit against the 2×8 and the lid to seal properly.
I then drilled the holes for the taps. I placed them all to the right so all the lines will be out of the way of the kegs and let me store the liquid lines out of the way.
 I then sanded the heck out of the frame and applied the first coat of the “shiny mix”
Here we are after about 5 coats, sanding after each coat had dried.
When the frame dried, I set it back in the freezer applying some kitchen adhesive between the frame and the freezer. When it dried a couple of hours later, I set the lid back on and set the hinges to the closed position and screwed them in the collar with some 2 inch screws.
 I then got the plumbing done. The CO2 lines can be cut to short convenient lengths. I made the initial mistake of cutting the tap lines to nice, short, lines for that clean appearance. Wrong! The tap lines need to be 5-6 feet long, It makes a huge difference!
I placed the probe in the center of the 4 kegs.
Here is the completed kegerater. I still wanna dress it up a little, maybe add a bottle opener, Drip Tray, who knows. The possibilities are endless.
The beauty of using the wood collar is it can be removed to restore the keezer to a freezer. Just in case you need to sell it and buy a bigger keezer.