Now that I have the new table saw fence that is much wider than my old one, I need a new out feed table. I kept it simple, birch plywood and standard pine 1×4. Here is a shot of the legs and supports for the long side.
I added 4×4 blocks to hold t-nut adjustable feed so I dial it in when ready.
I then put the sides on and slid it in place for a test fit:
I added in some cross members and dropped the top in place.
Put in the bottom shelf and slid it in place for a test fit:
Cut 3, 32 inch miter slots in and a couple coats of sealer
Here it is all ready for use and abuse!