Shop – Table Saw and Out Feed

Got everything moved in and starting to put it all together. The first thing to go back together is the Table saw. There was a little bit of rust on the saw and router table.


WD-40, steel wool, and a little elbow grease got most of it out. I am going to use metal polish and my normal maintenance to get it finished out:

Next I attached the shop made DIY – Biesemeyer fence rails and side table

Next up was the OutFeed Table. Pretty much the same as I did HERE. Couple shots of the new one:


I will put the bottom shelf and the miter slots in and call it done.